|Jan 27, 2013, 11:05 PM|
United States, AR, Maumelle
Joined Dec 2010
Trader Rating: 5
Getting out of the hobby.
I am no longer able to participate in this hobby due to work. Instead of it all sitting here, I have decided to sell all of my stuff. This is an all or nothing sell. $1750.00 OBO
I will not separate items.
I will not ship.
I will meet someone within 100 miles of Little Rock Arkansas.
Here is a link to all the pictures:
Due to the amount of stuff I have, I will not be able to list everything. Things like aluminum servos arms, servo extensions, nuts, bolts, screws, tools and support equipment will not be listed. You will be able to get an idea of whats there from the pictures.
Futaba Servos: (11 total)
S3152 3 NIB and 2 used. S3003 4 used. FP-S148 1 used. S9157 1 used.
Hitec Servos: (15 total)
HS-425BB 1 used. HS-645MG 1 used. HS-5645MG 2 used. HS-5955TG 3 used. HS-7985MG 1 used. HS-5985MG 4 used. HS-7955TG 1 used. HS-322HD 2 NIB. HPP-21 plus Programmer.
JR Servos: (1 total)
NES-537 1 used.
Spektrum Servos: (5 total)
DSP75 1 NIB. DS821 3 NIB 1 used.
Spektrum Receivers: (3 total)
AR7000 1 NIB and 2 used. All with remote antennas.
JR Receivers: (1 total)
R921 1 NIB with remote antenna.
Voltage Regulators: (6 total)
Flight Power FT5AVR 1 NIB and 3 used.
Unknown 2 used.
Ignition Kill Switch: (2 total)
Ignition Tachometer: (1 total)
Electronic Speed Controls: (2 total)
Skyartec BMC-25A 1 used. Electrifly C-12 1 used.
JR Matchmaker: (1 total)
JR Matchbox: (1 total)
Batteries: (8 total)
JR 4.8V NiMH 2700 MaH, JR 4.8V NiMH 2300 MaH, JR 6.0V NiMH 2700 MaH, JR 6.0V NiMH 2500 MaH TX Battery
Sanyo 4.8V NiMH 1650 MaH.
LiFE 6.6V 2100 MaH -2 used, LiFE 6.6V 3600 MaH 1 used.
Propellers: (17 total)
Master Airscrew 3 Blade 16x8, Master Airscrew 2 blade 18x6 used, 18x8 NIB.
Xoar 2 blade 24-3DA used, 24-10 NIB, 23-8 used, 23-10 used, 22-8 NIB, 20-6 NIB, 20-6 used, 18-10 NIB, 20-8 NIB, 20-8 NIB.
Mejzlik 2 blade 19x8 used, 20x6 NIB, 20x6 used.
Unknown 2 blade 24x?
Aeroworks 35cc Extra 260 and installed equipment:
Hitec HS-5955TG on rudder (1). Hitec HS-5985MG on throttle, elevators and ailerons (5). Spektrum AR7000 Receiver. Ignition kill switch. Two power switches. PTE 36R Engine (Engine has 2 15oz tanks through it. Great running. It also comes with an extra ignition and stock muffler). Wing bags. Aeroworks pilot. Aeroworks instrument panel. Cowl louvers. Titanium push rods.
Extreme Flight Jeremy Chinn Yak and installed equipment:
Futaba S3152 (4). Spektrum AR7000 Receiver. CF Control Rods.
Engine was used to power a hydraulic pump. Has about 9 gallons through it. It had broken a leg on the mounting plate and a screw in the prop hub. I bought all new parts to rebuild it minus the internals.
Unknown history. I bought it to rebuild.
DLE-30cc side carburetor:
Great running engine. Has about 3 gallons through it. Single nut prop hub conversion. I do have the conversion kit to make it a rear carb engine.
Chargers: (3 total)
E-Station Bc6, Turnigy Accucell-6, Electrifly Triton 2.
JR X9303 2.4. Comes with case, upgraded battery, upgraded sticks, and neck straps.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||Getting out of planes RC sale||CoronaL||Non R/C Items (FS/W)||15||Jun 09, 2013 10:01 PM|
|Discussion||Considering getting out of the hobby||RcAirplaneNoob||Electric Plane Talk||80||Jan 20, 2013 02:04 PM|
|Discussion||How to get the best out of your GoPro Hero 3||lovegroove||Multirotor Talk||1||Jan 19, 2013 05:47 AM|
|Discussion||Trying to get the most out of a PVC motor||mice1m||Rocketry||1||Jan 15, 2013 07:48 PM|
|Question||getting out of the sport, but...||GliderKing||Slope||0||Jan 05, 2013 04:20 PM|