|Aug 12, 2013, 09:36 PM|
United States, NY, New York
Joined Aug 2011
L-39 90mm flap not leveling !!!
So I started working on my htg l-39 flap mod. Sad to say, I made a big mess by sanding the leading edge of one flap by an extra 2 mm. Openings are identical and it was only one flap piece that was off. Remove the longer piece and shortened it by 2 mm to compensate for the shorter, thinking that the openings are equal sizes that I would give a 1 mm gap from the flap leading edge to wing to allow me to level flap trailing edge with aileron trailing edge.
All done and sorted! Issue now is I cannot seem to trim the flaps level. Same servo position on each side, same hole on horns.... One will always be higher than the other by a click or two.
What should I do to correct this. I have tinkered with the radio all day and have mechanically adjusted rods over and over again but with no success.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Aero L-39 Albatros 90mm EDF - 1200mm Composite||kclements||Aircraft - Electric - Jets (FS/W)||7||Apr 09, 2013 12:33 PM|
|Sold||Areodyne 90mm L-39 SOLD!!!!!!!!!!!!!!!!!!!!!!!||chopper52||Aircraft - Electric - Jets (FS/W)||6||Mar 20, 2013 09:36 AM|
|Sold||Areo 90mm L-39 SOLD!!!!!!!!!!!!!!!!!||chopper52||Aircraft - Electric - Jets (FS/W)||3||Mar 20, 2013 09:33 AM|
|Sold||HET 90mm fan L-39 Breitling 2010||3DTRYER||Aircraft - Electric - Jets (FS/W)||0||Mar 18, 2013 03:50 PM|
|Sold||Aero L-39 Albatros 90mm EDF - 1200mm Composite||kclements||Aircraft - Electric - Jets (FS/W)||5||Mar 09, 2013 06:44 PM|