|Dec 07, 2012, 01:15 PM|
Joined Feb 2012
Align trex 600 orientation tail vertical or horizontal 100%
Hello pleasure to greet.
This time I am writing to ask you to help me in and out of this great doubts about align trex tail 600efl pro super combo which is the heli I have. joining my heli, once you finish assembling the boom and the tail rotor, I noticed that the tail was not completely horizontal, if not, it was with a certain gap to the horizontal and vertical tail fin was not vertical if not protruding outward from the left side viewed from the rear. My question is this inclination is normal for align OEM or a defect in the boom came over the pilot holes, which makes the box look grand in difference with respect to the horizontal? To verify, level the table where sat the heli and check the level, then compare it to the queue and I could see the difference. Finally do not know if this applies to all or is only aligh heli that gives this small inclination to the tail of his helis, this inclination is normal, or should be completely the horizontal plane right? attached photos to supplement my doubt. Thanks in advance for your help.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||ALIGN TREX 550 600 131T M0.8 Autorotation Tail Drive Gear H60198||kayvannouri||Aircraft - Electric - Helis (FS/W)||0||Nov 28, 2012 11:39 AM|
|Sold||KDE Motor 700XF-495, Trex 700 Horizontal and Vertical Stabilizers||Curt S||Aircraft - Fuel - Helis (FS/W)||0||Oct 21, 2012 06:06 PM|
|For Sale||Align Trex 550/600/700 Tail Rotor Holders (2)||xxrando||Aircraft - Electric - Helis (FS/W)||0||Jun 13, 2012 04:24 PM|
|Sold||Align Trex 600 TT Tail assembly w/ many extras ($60 shipped FIRM)||Boomkidd||Aircraft - General - Miscellaneous (FS/W)||0||May 12, 2012 10:45 AM|
|Wanted||align T-rex 600 Hughes 500 scale vertical tail||sherlockshah||Aircraft - Electric - Helis (FS/W)||0||Sep 28, 2011 10:54 PM|