|May 26, 2013, 12:48 PM|
Where can I get a adaptor and pinion gear?
This is what I have.
Maxon 4.4 gear box P22 (22mm)
I guess I need a adaptor and a pinion gear.
Can anyone tell me where to get the correct parts (in the USA hopefully)?
|May 26, 2013, 02:57 PM|
Your best bet is Neu motors,
they can help you , if you tell them the bolt circle diameter (on motor) and thread pitch of the motor.
You may have to trim back the length of the motor shaft, then grind a flat spot on the shaft for the pinion. A special tool may be required to mount the pinion.
If the gear box you have now is even compatible at all. You may end up buying a whole new gear box from Neu Motors, just to get one that will fit your application..
here is a picture of some of the components that went into the build of a Bullet warmliner I fly now. You can see the Neu motor, 1105/2.5Y/with the 4.4 Maxon gearbox on the front. I think this is the same Maxon P-22 gearbox you have.
It might be easier for you to just buy one of these motor/gearbox combos from Neu Motors..
|May 26, 2013, 03:04 PM|
I just purchased a Maxon 4.4 gear box P22 from you (NEUTRONICS?: Invoice #0000000 XXX).
Your site description is
The popular Maxon4.4-1 gear drive set is available. It comes with a pinion gear to fit 3.2mm shafts.
Included are adapters to fit many smaller motors like our 1100 series with 19mm bolt spacing.
This gear drive is suitable for use up to 500 watts. Output shaft is 4mm.
I received the gearbox. No pinion gear. No adaptors. Can you send me the pinion gear to fit 3.2mm shafts and the adaptors (I am putting it on a Scorpion 2221-10).
|May 26, 2013, 03:14 PM|
Give them a phone call? 858-674-2250
Frankly, if I were you I would return the Maxon Gearbox for store credit (it is missing parts) and then just buy a Neu motor/ gearbox combo.
Neu 1105/2.5Y/ 4.4 . You'll get flying a lot sooner
|May 26, 2013, 04:10 PM|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Question Need help: What do you guys think of this motor and a 2kg hexa + 11"x4.5||CyberCrash||Multirotor Electronics||0||Apr 16, 2013 08:39 AM|
|Discussion Need Help . Do you know what engine this is???||Fastandlow||Engines||13||Mar 25, 2013 11:46 PM|
|Question What do I need to make this charger/Lipo connection?||XtalHunt||Batteries and Chargers||10||Feb 20, 2013 02:11 AM|
|Discussion HELP!!! What do I need to do to this cd rom to make it a pusher motor||sideshowbill13||Electric Motor Design and Construction||3||May 10, 2009 01:01 AM|
|So what's this nanotech going to do for us?||Pierre Audette||Indoor and Micro Models||4||Mar 17, 2003 09:54 PM|