|Feb 17, 2004, 02:38 AM|
Attach RX antenna to airframe
As a newbie I was unaware of the danger of having the RX antenna just dangling out of the model.
While doing a vertical stall the prop caught the antenna and snapped about 2/3 off it. Luckily I had the Berg-5 RX so the plane was unaffected by the loss of antenna length. Only after landing I saw that it happened.
If the antenna would have ripped out of the reciever instead of snapping my plane would have been toothpicks.
Lesson for today, tape that antenna to your model so it can't reach the prop.
|Feb 17, 2004, 02:29 PM|
St. Catharines, Canada
Joined Mar 2003
Another thing to do is to write down what your original antenna length was so you can solder on a proper replacement when your done your midflight snipping. The length is very important for optimum operation. 1m (39") is the norm for most but I think the frequency and type of tx can alter this.
|Feb 17, 2004, 02:45 PM|
I'm not sure what length of the Berg antenna is (hence your hint ) luckily the antenna wrapped it self around the prop shaft and stayed there without doing harm. So I soldered it back together with minimal loss of length. (maybe 1-2 mm).
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Hitec 555 RX Antenna Came out!||Tram||Power Systems||4||Nov 23, 2001 01:19 AM|
|Where to run RX antenna on Ky F16?||DeanW||Electric Ducted Fan Jet Talk||0||Nov 18, 2001 09:32 PM|
|Rx antenna re-attachment?||cold boy||Power Systems||3||Jul 04, 2001 01:14 AM|
|Increasing rx antenna length.||Erik Johansson||Power Systems||9||Jun 20, 2001 12:35 AM|
|Rx Antenna routing on an F5B fuselage||avalanche||Electric Sailplanes||3||Apr 23, 2001 12:50 AM|