|Feb 24, 2013, 12:04 AM|
Joined Jul 2012
NAZA Controller with Turnagy 9x
Guys, i need help. Setting up NAZA controller with Turnigy 9x TX, i also upgraded Turnigy with FrySky module.
This is what i am running in to: throttle is outputting signal to two channels (channel 3 on receiver and T on Naza and channel 6 on receiver and X1 on Naza)
This is new setup in TX no mixing or any other con-figs have been done. I tried two receivers, the same thing. When it's doing this i cant use channel six for anything.
Can someone point me to what can be setup wrong.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Turnigy 9x with DJI Naza – Problems with channel 5&6 for lights||sgtraven||Multirotor Electronics||1||Jan 11, 2013 11:15 PM|
|Discussion||9CH Turnigy 9x simple control 3-position switch setting and the Naza + GPS||raayd||Multirotor Electronics||0||Nov 11, 2012 02:48 PM|
|Discussion||NAZA GPS Failsafe with turnigy 9X and ER9x||brifa||Multirotor Electronics||7||Jul 27, 2012 09:29 AM|
|Question||SETUP Turnigy 9x with ER9X setup for NAZA?||Medicineman76||Radios||0||Feb 26, 2012 09:51 PM|
|Question||Turnigy 9x With Witespy w/Naza VC-450?||Medicineman76||Multirotor Talk||2||Feb 19, 2012 04:54 PM|