|
|
|
|
|
|
|
|
|
It is easier to use an oscilloscope or signal tracer to find the ppm on the board, the RF section would be around were the crystal socket is. The encoder is most likely a chip so after tracing the V+,Gnd and control pots pins there is only a few pins to check for ppm. Here is a conversion on a Sanwa wheel Tx with a one piece board too:
http://www.rcgroups.com/forums/showthread.php?t=1343702 |
|
|
|
| Thread Tools | |
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Discussion traxxas wheel tx - flydream 2.4 | swervo | Radios | 5 | Apr 23, 2012 11:43 PM |
| Sold Velineon VXL3m, 2.4 RX/TX, 1/16 SUMMIT TIRES AND WHEELS AND BODY | nightfiref7efi | Cars - Trucks and Parts (FS/W) | 2 | Feb 27, 2012 08:22 PM |
| Sold 2.4 Gz FlyDream Rx's plus Fut Hitex Tx Module | rlfgary | Aircraft - General - Radio Equipment (FS/W) | 0 | Feb 06, 2012 11:28 AM |
| Free (GONE) Hitec Focus 2 AM TX (2 and 3 channel) w/2ch RX | greghol | Free Items | 10 | Oct 13, 2009 01:26 PM |
| Alert Anyone want this 75MHz car-wheel Tx and 2ch Rx? .... from 1988?!! | Hogster | Radios | 10 | Mar 03, 2005 01:06 AM |