|Dec 30, 2006, 05:40 PM|
New servo comp. with ancient Futaba 6ch
I got the freq. issues cleared up with my old 1988 Futaba FP-6FG/K and after doing some range testing and flying, decided to look into some newer and smaller servos. What can I use that is readily available today? I understand I will have to solder on my old style connectors to use my old 2-ton RX. I see so many different types on the market and don't have a clue what will or will not work.
Thanks in advance....
|Dec 30, 2006, 05:55 PM|
Mainline servos are just about 100% "mixable". I say mainline because I am sure there are some servos that require an odd signal input. In short, any Futaba, Hitec, Airtronics, JR, or GWS will be just fine.
|Dec 30, 2006, 06:56 PM|
As Bill said, any modern servo will work with that vintage radio, though servo centering will be a tad off, but no bigie.
Just recently I was in a thread where this issue came up and someone named a scource of Futaba "G" to "J" connector adaptors, beats cutting off the new style plugs that you may well be switching to somewhere down the road
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|New low-end Futaba 6CH any good?||rdeis||Radios||4||Sep 22, 2005 05:11 PM|
|new futaba 6ch reciever $20||ergo||Aircraft - Electric - Airplanes (FS/W)||3||Nov 04, 2003 08:09 PM|
|Futaba 6ch skyport for sale with everything included||extremeflying||Aircraft - Electric - Helis (FS/W)||0||Feb 07, 2003 03:44 PM|
|Will a jr/airtronics pico servo work with a hitec/futaba r4-p?||Spaulding||Parkflyers||9||Mar 25, 2002 09:53 PM|