|Nov 18, 2012, 09:23 PM|
Joined Aug 2011
Drilling carbon props
I have a couple of PT props and need to enlarge center hole from 6mm to 8mm. I’ve never drilled in carbon before and better safe than sorry. I have an 8mm drill and always use a backing board for drill through most materials. What have you done?
|Nov 23, 2012, 12:19 AM|
North OC, Ca.
Joined Jun 2005
What they said AND put masking tape on both sides.
Use abrasive(diamond if available) bits and coolant(water is okay) if doing significant work.
Also keeps dust down.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||DA-50 PROP Drill JIG/Drill Bit/ Muffler gaskets REDUCED||wolfcbr2003||Aircraft - Fuel - Engines and Accessories (FS/W)||3||Nov 28, 2012 02:48 PM|
|For Sale||DLE 55 Prop Drill Jig and 3.5" Carbon Spinner||grubby||Aircraft - Fuel - Engines and Accessories (FS/W)||0||Aug 16, 2012 04:45 AM|
|For Sale||Props, Props, Props and Props. Full Carbon Fiber, APCs, GemFan CF Mix||Adidas4275||Aircraft - Electric - Multirotor (FS/W)||9||Jun 13, 2012 04:19 PM|
|Sold||Drill baby Drill with these 25" drill bits for the modeler in 3 sizes!!!||unclegeorge||Aircraft - General - Miscellaneous (FS/W)||0||Mar 23, 2012 10:08 AM|
|Sold||Drill baby Drill with these 25" drill bits for the modeler in 3 sizes!!!||unclegeorge||Aircraft - General - Miscellaneous (FS/W)||0||Mar 15, 2012 11:00 PM|