There are a few people who run near 60 amps on the CC 50's with no issues. YMMV.

Originally Posted by tominator06

Here is the first watts up test with it in the edge on the ice 75 and 13x6.5. This was right after i finished building it. Had not even flown it yet.
I ran it in the shp with the ice 50 on a 13x4 apc and xoar 13x5 and the amps were good.

http://www.youtube.com/watch?v=psk7xySAmvs

That is with the 2815-1025? So you got 57A max? I will be fine then with my x-55 since mine will be around 1000kv running a 13x6.5

Yes I think you should be fine Keith.

I cut short my flying today after two packs and I saw that two of my canopy magnets came out. No signs of CA either. Anyone repair theirs before, I am wondering if CA or epoxy will be best?

I used thick CA. This sounds like it may be a problem with some of the magnets from the factory, so everybody double check your magnets because mine were loose too.

When I have a new plane I go over the motor box and all four magnets on the canopy with thin CA. Works a charm.

Oh ok, I guess I'll be going over the magnets too, form now on.

I always go over the balsa but never thought of the magnets so it will be on my new plane checklist now too.

I've had several from different planes pull loose. Just make sure you get the polarity right before you CA them back in. Thick, Med, or Thin all seem to work. Yea doing this during initial build would be a good idea.

Originally Posted by Ohio AV8TOR

I always go over the balsa but never thought of the magnets so it will be on my new plane checklist now too.

Originally Posted by Eagle34

I've had several from different planes pull loose. Just make sure you get the polarity right before you CA them back in. Thick, Med, or Thin all seem to work. Yea doing this during initial build would be a good idea.

I've had the magnets come with the canopy when I pulled it off...CA's them back on and they are good to go now.

Originally Posted by Eagle34

Just make sure you get the polarity right before you CA them back in.

Wow good catch, thanks for the suggestion.

Originally Posted by Ohio AV8TOR

Wow good catch, thanks for the suggestion.

Yea don't ask me how I know. But it involved acetone.

Got home tonight to a package from Rob at ADC. I asked him if he could cut me a smaller version the the flag from the decal package I got for him on my 87" Extra SHP for my 47" SHP and he said no problem. He did a wonderful job. In the mean time I hand cut some matching flames also on my 87" so not they somewhat match. I am happy

My 87" is on the right

Build videos are up for the V4 SHP. Happy building....

3D Hobby Shop 47" Extra 300 SHP V4 Build Video #1 (9 min 14 sec)

3D Hobby Shop 47" Extra 300 SHP V4 Build Video #2 (8 min 39 sec)

3D Hobby Shop 47" Extra 300 SHP V4 Build Video #3 (10 min 27 sec)

3D Hobby Shop 47" Extra 300 SHP V4 Build Video #4 (10 min 21 sec)

3D Hobby Shop 47" Extra 300 SHP V4 Build Video #5 (11 min 19 sec)

I always enjoy your videos on builds, thanks.