|Feb 18, 2012, 02:12 AM|
Is this diagram correct?
Ill be running 10S...2 x 5S 3000mah packs. Im using a Castle BEC. Its good up to 6S. Can I pull voltage from just one pack as configured in the picture? I am trying to eliminate a switch I would need between 1 battery and the BEC.
In the pic, the arming plug, mounted on the outside, would power up the RX and the ESC.
|Feb 18, 2012, 07:43 AM|
No, that is NOT correct, do not hook it up like that
the "master negative" , i.e. where the negative goes to the ESC is where you have to have your negative cable to BEC.
|Feb 18, 2012, 07:59 AM|
I have this question in the Castle thread and it was a no go. Posted a new pic, but hadnt gotten an answer yet....this should work ...right? It shouldnt matter that the arming plug is on the negative....right?....is there a better way to do this?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Is this diagram correct?||Cabledawg1||Power Systems||6||Feb 18, 2012 01:23 PM|
|Suggestion||What do I need to do to correct this injustice?...||tdmosstristate||Site Suggestions / Complaints||1||Aug 13, 2011 09:01 AM|
|Help!||Is this correct motor, ESC and batterysetup?||djsong121||Power Systems||3||Jun 01, 2011 06:27 AM|
|Question||is this the correct way||Doushiyou12||Power Systems||9||Mar 20, 2011 12:53 AM|
|Discussion||Spektrum Receiver Bind Diagram, Correct?||sonicserve||Radios||4||Jul 25, 2008 09:24 PM|