|Jan 08, 2010, 06:59 PM|
Joined Mar 2006
how to add rudder to vapor brick
I can not find how to add the rudder port to the vapor green dot brick. I know that it is in the discussion but can not come up with the correct search. What i want to do is add the rudder channel plug to the vapor green dot reciever. then mix the throttle with the rudder and use a 1 cell esc on the rudder to drive the 2 gram brushless
can this be done?
where to I find the directions?
there are three pads on the reciever for the rudder which is the +, -, and signal?
|Jan 08, 2010, 10:55 PM|
For an external ESC you just need to solder the Signal wire to the board and then run +/- to the Bricks +/- wires. This is the easiest way if you don't have tiny solder skills.
Modfly's F-18 thread
or you can solder all three Like this
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||how to mount the vapor brick ?||dizzymarkus||Scratchbuilt Indoor and Micro Models||12||Dec 18, 2009 03:23 PM|
|For Sale||Parkzonce Vapor brick/fuselage, Parkzone Cessna brick, and some small motors||The Don||Aircraft - Electric - Micro & Indoor Airplanes (FS/W)||7||Nov 16, 2009 03:52 PM|
|Discussion||Vapor and Sukhoi Brick: How Reliable, Durable and Easy to Maintain?||flying-llama||Micro Ready-to-Fly||2||Nov 02, 2009 11:05 PM|
|Question||how to swap rudder and aileron on vapor brick?||indoor_fr||Scratchbuilt Indoor and Micro Models||3||Oct 28, 2009 05:49 PM|
|Help!||DX7 Binding to Vapor Brick --- HOW?????||termite||Scratchbuilt Indoor and Micro Models||7||Oct 19, 2008 10:45 PM|