|May 31, 2013, 05:54 PM|
I got the tray for the fuel tank re-installed today. Then I re-installed the glow driver battery, and fixed the fuel tank into place. It is a fairly tight squeeze-fit as is but I also used a piece of double sided tape. Because the VQ factory drilled the hole in the firewall for the fuel tank, too large, I will need to pack some wadding around the neck of the tank. I also got the carb control rod sheath glued into place.
All for now.
|Jun 02, 2013, 07:43 PM|
Today I installed my Rx switch into the cockpit. I will use a servo extension wire to connect it to the power panel.
I also needed to position the glow driver telltale LED and I found myself in a bit of a quandry. I really wanted to place it inside the cockpit, but that would mean I would have to walk around the wing to look at the IP every time I needed to see it. I really did not want to stick it on the side of the fuselage.
But, logic won out and I placed it on the side of the fuselage. I also placed it on the side that will be closest to me when flying so that I can see it more easily when the plane is in the air. We typically fly a CCW pattern at my field.
Since I finally got around to install the Rx switch, it was now okay to permanently stick down the pilot. I used some double sided tape and also a bolt. Then I CA'd around the bolt so it won't back out.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Question VQ Fly Baby question - Mounting servos on balsa sheet??||Kmot||Giant Scale Airplanes||6||Dec 27, 2012 06:12 AM|
|Rave VQ Models Fly Baby!||GoBeach75||Scale Electric Planes||3||Sep 08, 2012 08:05 AM|
|For Sale Balsa USA Fly Baby Bipe 1/3 scale kit NIB||nero1156||Aircraft - Fuel - Airplanes (FS/W)||0||Jun 03, 2012 04:41 PM|
|For Sale Balsa USA Fly Baby Bipe 1/3 scale kit NIB||nero1156||Aircraft - Fuel - Airplanes (FS/W)||0||May 27, 2012 06:25 PM|