|Nov 09, 2012, 06:41 AM|
Joined Dec 2003
Airspeed v3 not working
I recently bought(esprit) an airspeed sensor to use standalone.
It is a v3, however it is not reading any speed at all.
even with short 1" pieces of tubing connecting to the pitot there is no change from the 0/zero reading.
The pitot tube appears to be good,
centre hole is clear to see through and the 45 one can blow to the side holes.
Any suggestions ?
|Nov 09, 2012, 04:18 PM|
Hi, if you blow gently into the end of the pitot tube, does the sensor not flash a non-zero number?
If not, the first thing I would check is to make sure you have the hoses connected correctly (not backwards). Please check the hookup diagram in the manual here.
|Nov 12, 2012, 01:34 PM|
if you connect a rubber tube to only the + input of the sensor (shown on the label) and blow into that, do you get a non-zero reading?
If not, the sensor is defective. Please open a ticket with us at http://ticket.eagletreesystems.com and we'll get it replaced for you.
|Apr 08, 2013, 05:05 PM|
You probably haven't heard anything because the folks aren't back and ready to get at it again after returning from the big RC Show in Toledo, OH this past weekend.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Help! Elogger V3 and Video OSD distance not working||solars||Eagle Tree Systems||2||Aug 23, 2012 10:37 PM|
|Discussion Help with Plush 30A & Paris V3 not working||thepelell||Multirotor Talk||3||Aug 06, 2011 09:28 PM|
|Discussion wasp V3 6 ch throttle not working||newbey1||Skyartec||5||Mar 10, 2011 06:24 AM|
|Discussion E Logger V3 RPM with CSM Revlock 10 sensor not working||sg sailing||Eagle Tree Systems||5||Jan 08, 2010 05:13 PM|