|Sep 29, 2013, 07:22 PM|
Joined May 2011
Hey I know it's not good but that can sometimes take a few days before I reply to mail.
Because I have a lot of work and FPVlongrange is a hobby and therefore it may take a few days between I read the mail.
|Nov 24, 2013, 02:08 PM|
Joined Mar 2012
I have recently purchased the UHF repeater system and it is not working with my EzUHF.
I have programmed the repeater to 8ch and I am using my Spektrum Radio/Receiver.
I know that all of the wiring is correct, but no matter what I do, my EzUHF will not correctly startup. When I power on the EzUHF, it just starts beeping, signaling that it is not receiving a good PPM signal from the repeater.
Here are more details of my setup:
There are four wires coming out of the ezuhf cable. I have connected the red one to the yellow signal wire on the repeater, and the white wire on the ezuhf cable to the black wire on the repeater system. I know that this is the correct assignment of cables as I have tested where each cable does goes with a multimeter. I have tried switched modes on the repeater to both 8ch and 9ch, but neither works.
I know that this whole problem is not because of the ezuhf because it works fine when it is connected directly to my Spektrum Dx18.
Any help would be appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Yippee! DRAGON LINK - New V2, Professional Grade Long Range FPV System, Always in Stock !||JettPilot||FPV Equipment||25296||Today 07:25 PM|
|Question UHF System Can connect to the 7 Channels Radio System ?||RanDavari||FPV Talk||7||Nov 15, 2011 11:04 AM|
|Suggestion Flyinjrc74 repeatedly abusing the feedback system.||flyer368||Site Suggestions / Complaints||1||Nov 11, 2011 02:22 PM|
|Discussion Alternative to expensive UHF system||fpvguy||FPV Talk||1||Sep 20, 2011 12:32 AM|
|Discussion How do I switch off 2.4 Ghz system when I only want to use UHF system?||Voguna||FPV Talk||1||Oct 07, 2010 07:16 AM|