are you going to do a firmware release notes on the support site for this so we can see what it entails?

i have tried everything uninstall reinstall but still no board in the "select board" section

A long shot and probably not the reason but it might be worth trying another usb cable just in case?

Originally Posted by flytahiti

i have tried everything uninstall reinstall but still no board in the "select board" section

i have tried this to

Usb cable or port i find sometimes

no i ve tried

I nearly give up and trow away the board, I do plan to give free to RC group member. Now I damage two servo, but...

Today I did install the new firmware and it seem great.
Will show the VDO, thanks for HF but I do not understand why such an important information you do not try to announce it clearly. It seem good now.

Ok. It is a holiday here in the states. We pushed the latest firmware out so you would have it but didn't do a good job getting info out about the release.

Everyone will be back in the office Monday.

Let hope that you will come back from holiday and see my good result on Monday.

Thanks.

i have updated firmware from 0.92 to 1.00 ,but i get control with TX only on pan not on roll and tilt , but stabilization was fine . So i came back to 0.98 and everything is fine ,no more roll drift . any info about 1.00 firmware issue ????

Ok, I got my board and started setting it up. Two things I have noticed so far. My throttle only works from mid stick and up or visa versa if i reverse the throttle...it works fine when just plugged into the receiver and gimbal servos but once i add the hoverfly gimbal board to the equation it wont move the servos from 0-50% throttle...default transmitter model. Also, I can get it to compensate correctly for roll and tilt but even when set to compensate for yaw it wont...and all of my options are greyed out in servo configuration. All I can do for channel 3 yaw is auto compensate, center point and enable yaw servo...what am i doing wrong. Also, once i get the max throws i want while manually using my radio, how do i keep the hoverfly board from maxing out past those? Thanks!

have you updated the board to firmware 1.0? (per the yaw stuff)

Originally Posted by Adidas4275

have you updated the board to firmware 1.0? (per the yaw stuff)

Yea, update to 1.0 then back to .98 to see if that would make it work then back to 1.0 again.

I have the option for test1 or 1.00 firmware...i am using 1.00

also, in the greyed out boxes, mode switch is preselected and i cant change it.