|Feb 17, 2013, 03:41 PM|
Joined Feb 2013
RDS Servo Repair F3B Target
I have had a mishap with one of my flaps and now either the servo is loose, or the RDS mechanics are.
I have studied this thread:
on how to rectify the problem.
Two questions that remains unanswered:
1) How do you cut a hole into the wing to end up with the tidiest lid solution? Is the weapon of choice
-a dremel with a small cutter (ragged edges of lid?)
-or rather a cutter with some sort of pattern to cut around?
2) How do go about fixing the RDS linkage which goes from the servo to the flap? This is not accessible from the servo lid.
Any experience welcome. Thanks!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Build Log||Tanga F3b, Rds Build||fnnwizard||Multi Task F3X||65||Sep 13, 2009 02:26 AM|
|Sold||Europhia 2V - F3B Mint "as new" with RDS||aussief3b||Aircraft - Sailplanes (FS/W)||8||Mar 20, 2009 09:22 PM|
|Sold||F3B Europhia 2V w/RDS near mint condition - 2 available||dbarker||Aircraft - Sailplanes (FS/W)||5||Sep 17, 2008 01:11 PM|
|Discussion||F3b Ceres with RDS install||djklein21||Multi Task F3X||246||Jul 21, 2008 04:07 PM|
|Discussion||Evolution F3B with RDS install||guillaume83||Multi Task F3X||29||Dec 23, 2007 12:41 AM|