|Jul 16, 2011, 01:02 PM|
fpv stryker futaba 7c
hi guys ive searched high and low for info i need im currently turning my stryker f27c into a fpv platform im running on all stock setup with a chainlink uhf radio installed the problem im finding is for the life of me i cant set my radio up for the mixing i have ch1 left elev ch2 right elev ch3 throttle that bit im ok with ive tried reading the manual but it mind boggles me lol.. im trying to set the radio up from scratch basically ive searched everywhere but to no avail i would be very grateful if someone could help ...mark
|Jul 16, 2011, 01:17 PM|
You want elevon mix.
Turn 7c on, hold down Modes/Page button until it beeps then release and press the Modes/Page button again, that should take you to mixing options. Toggle down and enable elevon mix. Plug your servos into aileron and elevator channels.
Edit: If you're having problems getting the control surfaces to deflect the correct way, Make sure both elevator and aileron channels are "Normal" and not "Reversed", now just swap over the servos to opposite channels(unplug elevator and plug it into aileron, unplug aileron and plug it into elevator).
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Futaba 7C FASST||dnjbenner||Aircraft - General - Radio Equipment (FS/W)||2||Jul 03, 2011 10:53 PM|
|Discussion||Futaba 7C P-Mix Question||modbuilder||Radios||1||Jun 26, 2011 08:44 AM|
|Question||Stock ESC Stryker PNP and Futaba 7C PCM rx||rclab1||Beginner Training Area (Aircraft-Electric)||0||Aug 18, 2010 06:45 PM|
|Sold||Spectrum DX7, Futaba 7C PCM, and some FPV equipment||CRJ700||Aircraft - General - Radio Equipment (FS/W)||0||Aug 21, 2009 05:02 PM|