|May 16, 2013, 10:56 AM|
Wichita, Kansas, USA
Joined Jul 2003
APM 2.5 Configuration File for X8?
Does anyone have an APM 2.5 configuration file for an X8?
|May 24, 2013, 02:57 PM|
All the APM 2.5+ hardware is the same; you just click on an icon in the Mission Planner to tell it what kind of vehicle you want to use it with (multicopter, plane, rover, traditional heli, etc) and it automatically loads the correct firmware.
The Mission Planner is Windows-only, but once you've loaded the correct firmware you can use any Ground Station, including QGroundControl (Win, Mac and Linux) or various mobile/tablet GCSs, such as Andropilot and Droidplanner.
The APM community and support is at DIY Drones, so you'll get the best help in using it over there.
copied from chris anderson post.
|May 24, 2013, 10:34 PM|
Hi Jimmy, your best chance of getting the config file is on the DIYDrones forum.
There's a forum for collecting copter config files but none for ArduPlane files (that I could find).
If you post a request in the 'Aircraft Platforms' forum you will probably get a good response.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||APM 2.5 ReadytoFlyer 2.5 with GPS 915Mhz Telemtry, Mavlink OSD and 3dR case||Wingbreaker||Aircraft - Electric - Multirotor (FS/W)||2||Feb 28, 2013 11:38 AM|
|Sold||APM 2.5 ReadytoFlyer 2.5 with GPS 915Mhz Telemtry, Mavlink OSD and 3dR case||Wingbreaker||FPV Equipment (FS/W)||0||Feb 28, 2013 11:26 AM|
|Found||ArduPilot 2.5 - APM 2.5 or Arduflyer||jjmelo||Aircraft - Electric - Multirotor (FS/W)||13||Feb 12, 2013 03:13 AM|