|Apr 12, 2014, 05:10 PM|
FZ5: design phase
So time to start a new design.
Alternative to the FZX design, this one has the duct inlet on top.
This makes it possible to install a retract in the belly.
Early design attempt .., wings later, once COG of fuselage is estimated
|May 04, 2014, 06:39 AM|
Searched YouTube for tutorials, they helped a lot.
Sketchup is pretty different, but i believe that the logic of 3D design is generic ?
Nevertheless, i Only use a fraction of its possibilities, no doubt.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||How well would this canardish jet perform? (just design phase right now)||GreenAce92||Foamies (Scratchbuilt)||5||Jan 16, 2009 07:14 AM|
|More shots with the Depron Dragon and Panasonic DMC-FZ5||CactusJackSlade||Aerial Photography||7||Jun 12, 2005 12:46 PM|
|Yippee!||Depron Dragon w/Panasonic DMC-FZ5 - maiden photos||CactusJackSlade||Aerial Photography||11||Jun 11, 2005 09:37 PM|
|Depron Dragon's new Panasonic DMC-FZ5 camera set-up - maiden this evening?!||CactusJackSlade||Aerial Photography||1||Jun 11, 2005 12:30 AM|
|New A/P Plane - Initial Design Phase||Buzz_Man||Aerial Photography||4||Apr 21, 2005 12:33 AM|