|Nov 08, 2011, 01:04 AM|
PowerLab 8 Presets for LiIon and LiManganese
I can find no presets for either LiIon or for LiMn batteries.
I would think that these should have been provided with the charger since the specs specifically state the charger works with them.
Have I just missed this? I did a search of the manual and these batteries only show up in the specifications.
Where do we go to get or share presets. Does FMA have a site specifically for us to download more presets?
|Nov 08, 2011, 07:51 AM|
LiIon charge the same as LiPoly.
Very old LiIon were marked as 3.6V and thus can use the LiPoly Long Life 4.1 Preset.
Newer LiIon are marked 3.7 (same as LiPolys) and thus can use the LiPoly Presets.
There was a request for a higher voltage (charge to) months ago and the upper available limit in LiPoly was increasted to 4.3 V.
Remember that you can remame and modify the Presets to match your needs.
There was talk of FMA creating a data base to share custom fuel tables but this has not happened as yet. It is very simple to create then save any Preset and thus share it with other PL8 owners.
Care to post requirements for charging LiMn as a refresher?
I seem to remember that LiManganese charge tge same as LiPolys or atleast the ones from years back did.
|Nov 17, 2011, 04:57 AM|
Not an expert in batteries. That is why I expected FMA to setup a database of verified presets we could download.
All of my other chargers use a different cell voltage for LiIons.
Also, FMA advertises that this charger is for LiMn and LiIons. So I would expect them to have presets already available for us. Why make each user have to develop/setup a preset for something the charger is advertised to do?
I will do some research but feel that FMA should be the one doing this for us.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Powerlab 8 Parallel Charging||KAW_Concours||FMA Direct||36||Sep 30, 2012 11:47 AM|
|Discussion||Powerlab 8 regenerative discharge question?||Eddie500||FMA Direct||11||Nov 09, 2011 04:05 PM|
|Discussion||PowerLab 8 IR Measurements||squid||FMA Direct||1||Sep 13, 2011 04:27 PM|
|Question||Powerlab 8 for $200?!||lipper2000||FMA Direct||7||May 18, 2011 11:54 PM|
|Discussion||PowerLab 8 V2 - Safety Code 52||martinwinlow||FMA Direct||3||Apr 24, 2011 04:39 AM|