Originally Posted by sandydr
I'm stuck again
I have cut and shaped the wing tips so far to match the rib, but I am struggling to understand the plans regarding the wing tip edge. I don't quite understand what the curves and lines mean in reference to the variable wing tip height. Any light you can shed would be most appreciated.
Those curved lines show the wing tip cross sections at the three points. When shaping my wing tip is I used those curves to make three templates. I then used those templates to shape the bottom of the wing tip. Note that the top of the wing tip is straight across in line with the top of the wing. When shaping the wing tip material is removed only from the bottom.
Your next task is to shape the top of the wing tip block to match the outline of the top of the wing tip drawing. Then remove material from the bottom of the wing tip to match the templates.