|Jan 29, 2013, 11:20 PM|
Hello, i've jury-rigged a thrust tester, but im having some trouble with the prop adapter.
Whats happening is the prop adapter uses a grub screw, but the motor doesn't have a flat part for the screw. This is an easy fix with a dremel, but what worries me is the amount of thrust it takes to pop off. When i pull it off by hand i record over 5 kg of pulling, but when it pops off rotating its only pulling .6kgs
any particular reason for this?
|Jan 30, 2013, 05:00 AM|
You are indeed correct, i just looked at it after i induced a pop off and it was loose.
I will be buying some tomorrow. Could i loctite the smooth shaft too or does it only work on threads?
|Jan 30, 2013, 11:07 PM|
So i rerigged the tester. I was unable to stop the pop offs, so i have combined the loctite with a ground notch into the side of the shaft for it to rest on.
It is working admirably now
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Esky EK2-0906 Battery Tester||N3SHXX||Aircraft - Electric - Multirotor (FS/W)||2||Jan 20, 2013 12:47 PM|
|Sold||Esky EK2-0906 Battery Tester||N3SHXX||Aircraft - Electric - Helis (FS/W)||3||Jan 20, 2013 12:46 PM|
|Sold||Esky EK2-0906 Battery Tester SOLD....!!!||N3SHXX||Aircraft - General - Radio Equipment (FS/W)||0||Jan 20, 2013 11:01 AM|
|Sold||rc parts, Battery connectors, low voltage buzzers servo tester more||ronzer||Cars - Trucks and Parts (FS/W)||5||Jan 18, 2013 11:49 PM|
|Wanted||Servo Tester||Davidpe||Aircraft - General - Miscellaneous (FS/W)||2||Jan 10, 2013 01:24 PM|