|Feb 24, 2014, 07:39 PM|
Joined Nov 2013
I own a KK2.1 Flight Control Board and would like to set it up.
I have been trying to flash my USBasp programmer for hours now. I downloaded the driver as well as the KK Flash Tool.
I went to Device Manager, manually updated the USBasp and when I try to update it again, it says "The best driver software for your device is already installed".
When I try to flash it with the KK Flash Tool, I get the error that you can see on the attached picture.
Would you PLEASE be able to help me?
Thank you so much in advance!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Atmel Atmega Socket Firmware flashing tool with USBasp||Chad2323||Aircraft - Electric - Multirotor (FS/W)||1||Jan 24, 2014 07:04 PM|
|Discussion||turnigy 9x USBasp will only flash if radio is on||htuong95||Radios||1||Jan 24, 2014 06:46 PM|
|Wanted||USBasp programmer for flashing ESCs||redcard1||Aircraft - Electric - Multirotor (FS/W)||10||May 22, 2013 12:58 PM|
|Discussion||USBasp FLASHING 6a ESC help needed||nicholas leigh||Multirotor Electronics||0||May 05, 2013 01:42 PM|
|Found||USBasp tool for KK flash needed||doubledown||Aircraft - Electric - Multirotor (FS/W)||3||May 02, 2013 04:38 PM|