|Oct 12, 2002, 01:03 AM|
Joined Oct 2002
How bout this zagi setup?
Okay, I read a couple books and now know enough to be dangerous.
In my quest to fine a reasonably priced hop up for the Zagi I have put together a list of what I am thinking of doing now...the push/pull config is still leaving me very much desiring an improvement in climb, and I wouldn't recommend it to others...
Being a poor student and modeling don't mix well...especially when looking at hop-ups...brushless setups are out of my reach.
Here is what I am looking at...not sure on some things, so please make any recommendations/suggestions.
Kyosho Endoplasma 16x2 ($19.99)...adjust timing to last tic mark appropriate way for reverse running.
Looking at 3
a. Cox 3 blade pusher: 5x3.5
b. Zinger pusher: 7x4
c. Zinger pusher: 8x4
(I know I have acces to these locally for replacement)
7-8Cell RC-3000Nimh or the new Sanyo 2600 Nicad in 7-8 Cell.
System till be drawing in the area of 30-40A as far as I can tell, so probably the Nicads.
May try 10 cells...but really don't want to change the brushes and have the arm. turned that often from what I read.
Great Planes 50a ESC
Take an additional 2" off each wing tip for a total of 4" removed.
(I know I should have gotten a razor for what I wanted, but this is what I have now)
My thanks in advance for any recommendations you guys can give on the specific setup.
|Oct 12, 2002, 02:39 AM|
You are better off cutting The 4 Inches out of the Middle. You do notwant to becuttingthe tips off.You will thank yourself in the long riun and it is not really all that much more work..
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion how bout this plane???||rotccapt||3D / Fun Fly Fuel Planes||4||Sep 08, 2006 02:59 PM|
|How about this brushless setup?||ipjodan||GWS (Grand Wing Servo)||22||Mar 08, 2005 03:02 AM|
|How 'bout this pump?||R. Carver||Composites Fabrication||1||Aug 12, 2004 01:28 AM|
|Alert How's this heli setup look?!||Silverstreak328||Micro Helis||11||Aug 09, 2004 12:35 PM|
|How's this Nemesis setup?||Cubby Boy||Power Systems||2||Sep 02, 2003 10:03 PM|