HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Aug 23, 2012, 09:43 AM
Registered User
Crumpled's Avatar
United Kingdom, England, Hockley
Joined Aug 2008
20 Posts
Question
CRIUS AIO board query

Hi, sorry if this is a silly question, I'm a noob at this. I've been trawling through threads but can't find an answer.

I have just brought a CRIUS AIO board and am going through the process of configuring it. Unfortunately the USB socket doesn't seem to have been very well attached and has broken off. I've raised a query with the company I brought it from but they are being quite slow in responding...

I have a small FTDI conversion boad and wonder if its possible to connect this to any other part o fthe board to egain access to configure it etc. There are a number of ports around the edge, I'm just not sure which or if I can use one to gain access?
Crumpled is offline Find More Posts by Crumpled
Reply With Quote
Sign up now
to remove ads between posts
Old Aug 23, 2012, 12:40 PM
Ape-pilot Extraordinaire
TS00's Avatar
Canada, NB, Moncton
Joined Jun 2011
1,501 Posts
FTDI port is on the right hand side, top connector. GND is at the top.
TS00 is offline Find More Posts by TS00
Reply With Quote
Old Aug 27, 2012, 02:03 AM
Registered User
Crumpled's Avatar
United Kingdom, England, Hockley
Joined Aug 2008
20 Posts
Thanks.
Crumpled is offline Find More Posts by Crumpled
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Crius MultiWii AIO boards Katch Multirotor Electronics 4177 Mar 29, 2014 01:20 PM
Discussion APM2.5 vs CRIUS aio pro little nellie Multirotor Talk 43 Dec 12, 2012 11:39 AM
Help! Crius MW AIO Pro Tx, Rx flash but no up-dates Flying Canuck Multirotor Electronics 3 Aug 23, 2012 04:38 PM
Question CRIUS AIO v1 config Crumpled Multirotor Talk 1 Aug 18, 2012 04:37 AM
Question Crius MultiWii AIO Vs. Naze32 vineet_p Multirotor Electronics 5 Aug 08, 2012 07:40 AM