|Mar 10, 2013, 09:46 AM|
Joined Mar 2013
Basic bladder moulding techniques
I'm actually trying to make a carbon fibre tube with an oval profile and a 45 degree bend. I have never used carbon fibre before and I have been reading as much as I can on the web. This forum is by far the best source of info. that I have found so far. There seems to be a huge amount of experience here and I was hoping that someone could give me some basic pointers to get started.
I intend to make a fibreglass mould - I would like to have one CNC'd from aluminium but can't really afford that at the moment. I also intend to make a bladder with the technique described by one of the guys on here. Adam I think. with stretch plastic membrane.
The layup is puzzling me a little though, I presume that for a tube part, a carbon fibre sock/sheath would be the best option both for structural strength and also for the finish. Would people agree?
The part has to be very strong taking 220lbs maybe even more as well as considerable shock load - could anyone give me any iideas what kind of thickness of material might be required. I will do a lot of testing but as the materials are quite expensive where I live I'm hoping to find out as much as I can to begin with.
Also anyone know any good resources to start learning about composite fabrication?
Thanks a lot in advance.
|Mar 11, 2013, 12:58 PM|
Here is a handbook
Also some good articles here.
|Mar 11, 2013, 03:34 PM|
North OC, Ca.
Joined Jun 2005
Shock load and carbon generally do not mix well.
Glass composites are strong and more durable.
Bends in fiber reinforced parts should have larger radius bends to avoid stress concentration.
|Mar 12, 2013, 04:53 AM|
If you were to describe the application, others could respond more meaningfully.
Your bare statement above is just about meaningless to the reader.
I'm with Sarmoby here. Also, carbon is not a good material to start to learn composites with. It's harder to use than glass, much more expensive and less forgiving of less than optimum layup technique etc.
As for composite information, just keep reading these forums. Lots of good information and generous help available. Good luck.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||looking for a very basic mould making video||gazza2003au||Composites Fabrication||1||Oct 10, 2012 05:21 PM|
|Discussion||Bladders with internal moulds||Aerogance||Composites Fabrication||11||Oct 05, 2012 09:39 PM|
|Discussion||Depron moulding technique||epilot||Scratchbuilt Indoor and Micro Models||24||Jan 01, 2010 08:09 PM|
|Casting and moulding techniques required!||vintage1||The Builders Workshop||18||Aug 25, 2004 04:37 PM|
|Vacuum Bladder Technique Info wanted||Tiramisu||The Builders Workshop||1||Dec 23, 2003 05:11 PM|