HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Jan 19, 2005, 12:38 AM
Registered User
Back in socal!
Joined Apr 2003
1,084 Posts
CD motor question. 25 mm Toshiba 5701B

I know this has been answered probably 100 times before but I just spent two hours trying to find the answer. Hopefully somebody can lead me in the right direction.

The best CD motor that I have ever seen was some that Birdie built us. They were made from Toshiba 5701 drives with 25mm motors. Well I bought 5 tore them all apart and now have the stack shown in the picture. Now I am trying to break them down further but cant seem to figure it out. On the backside of the shaft there is a small snap ring I took it off but the bell wont pull off. Any suggestions? Anybody use these before?

Thanks alot!
BC
bcripe1 is offline Find More Posts by bcripe1
Reply With Quote
Sign up now
to remove ads between posts
Old Jan 19, 2005, 12:44 AM
Registered User
Back in socal!
Joined Apr 2003
1,084 Posts
Heres a better picture. Thanks again,

BC
bcripe1 is offline Find More Posts by bcripe1
Reply With Quote
Old Jan 19, 2005, 12:55 AM
Good Better Best quest.
olmod's Avatar
Australia, VIC, Cranbourne East
Joined Apr 2004
10,513 Posts
have you got a bench drill ?
olmod is offline Find More Posts by olmod
Reply With Quote
Old Jan 19, 2005, 02:33 AM
Flying motor mount master
fly_boy99's Avatar
San Jose, California, United States
Joined Oct 2004
8,745 Posts
I have a few of these. You need to take the cotter pin out
from the very back. This will release the 3mm rod and then you
can take the can off.

Then you take like an 8mm socket and place it on the center
of the bearings(at the front). Give it a couple of good taps with
a hammer and it will shoot out the back. You can then take
the bearing tube and reattach it or use something else.

Cheers,
fb


Quote:
Originally Posted by bcripe1
Heres a better picture. Thanks again,

BC
fly_boy99 is offline Find More Posts by fly_boy99
Reply With Quote
Old Jan 19, 2005, 09:29 AM
Registered User
Back in socal!
Joined Apr 2003
1,084 Posts
I take the ring off but cant pull the bell off. Does it take alot of force? Then how do you get the shaft out of the bell?

Thanks!
BC
bcripe1 is offline Find More Posts by bcripe1
Reply With Quote
Old Jan 19, 2005, 09:31 AM
Registered User
Back in socal!
Joined Apr 2003
1,084 Posts
Yes we do have a drill press.

Thanks,
BC
bcripe1 is offline Find More Posts by bcripe1
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question Idiot-level CD Rom motor question. mad mike Power Systems 7 Dec 09, 2010 09:31 PM
DIY CD motor question FLYRCM Beginner Training Area (Aircraft-Electric) 2 Oct 18, 2005 05:23 PM
Homemade cd motor question. Rob1953 Power Systems 10 Jan 02, 2005 02:40 PM
axi 2212/25 motor question Dennis Everett Power Systems 9 Dec 26, 2003 08:13 PM
Phoenix 10 and CD-ROM motor question jiri Castle Creations 12 Nov 14, 2003 04:58 PM