AR7000 rX problem
I have a brand new AR7000 RX that came with the DX7 TX. As I never had a use for it until now (no 7 channel airplanes in my fleet) I decided to hook it up and test it. I used the switch that came with it and bound it according to the instructions to the TX. The light blinks and then goes solid, stating it is bound. However, no servos seem to work. I tested a AR6000 RX to see if I was delusional, but that RX works fine. Now a friend of mine has the exact same AR7000 RX and the same thing happens.
IS this just a bad RX or is there something else needs to be done? Such as update firmware etc.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||2 AR7000 RX's for sale||ryan_m||Aircraft - General - Radio Equipment (FS/W)||3||Feb 24, 2012 01:56 AM|
|Sold||AR7000 Rx with Remote Rx.||rudyy||Aircraft - General - Radio Equipment (FS/W)||1||Jan 23, 2012 06:39 AM|
|Sold||Spektrum DSM2 AR7000 RX with Satelite RX||crosby||Aircraft - General - Radio Equipment (FS/W)||6||Nov 11, 2011 01:52 PM|
|Discussion||AR7000 RX Ni-Cd 4.8v 700mah problem...||LaurenceGough||Radios||9||Dec 18, 2007 01:24 PM|
|Discussion||AR7000 RX Ni-Cd 4.8v 700mah problem...||LaurenceGough||Batteries and Chargers||5||Dec 18, 2007 12:19 PM|