Joined May 2013
is it dangerous to cut small triangle in the wing to fit retracts?
I'm new in this forum and i would like to have your opinion for a problem i have or maybe better... a solution...
Lately i bought a set of electric retracts to my hangar 9 spitfire , which did not fit to my plane...
While fitting it i hat to cut a triangle hole in the bottom side of the wing, as can be seen in the pictures.
I'm am afraid that a air that will go into the wing will tear the wing a part.
What shell i do?
I did not fit the other wheel since i did not no if to do the same or to remove the triangle part from the retracts...
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||How do I KF a triangle wing?||himeros||Foamies (Scratchbuilt)||7||Jan 16, 2013 12:27 PM|
|Discussion||AAAA batteries to power small R/C glider? Hidden in 9V battery? ***DANGER***!!!!!!!||Little-Acorn||Scratchbuilt Indoor and Micro Models||9||Aug 28, 2009 05:38 AM|
|Discussion||***DANGER*** - cheap&easy small batteries for small, cheap 24" styro glider||Little-Acorn||Batteries and Chargers||5||Aug 27, 2009 01:03 PM|
|Fitting Retracts in a foam wing??||lordspyro||The Builders Workshop||0||Feb 24, 2005 10:39 AM|