HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Aug 08, 2014, 02:40 AM
Registered User
United States, CA, San Diego
Joined Dec 2005
23 Posts
Discussion
how to enable telemetry output on futaba module?

is there a way to hookup the signal to arduino board to display RSSI and voltage?
I tried to monitor the telemetry signal lines on futaba module but I could not see anything (unlike EVO MLINK emulation)
is there anyway to enable that port?
kylekyle is offline Find More Posts by kylekyle
Reply With Quote
Sign up now
to remove ads between posts
Old Aug 08, 2014, 09:24 AM
Xtreme Power Systems
Lake Havasu, AZ
Joined Jun 2005
15,824 Posts
There is no information available from the JR or Futaba modules.
JimDrew is offline Find More Posts by JimDrew
RCG Plus Member
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Question Enabling PPM-Output on HK ORX OpenLRSng qube FPV Equipment 3 Aug 21, 2014 07:55 AM
Discussion How to enable a mic on the Boscam TX? gekanukr FPV Talk 5 May 24, 2014 06:25 PM
Discussion Futaba telemetry sensor to rcexl rpm output brettc Radios 0 Apr 19, 2014 06:35 PM
Sold FrSky Futaba Telemetry Module and Telemetry Receiver Dan777 Aircraft - General - Radio Equipment (FS/W) 1 Jul 08, 2012 08:46 PM
Help! FrSky DJT Telemetry modul on Futaba FF7 saxon0010 Radios 2 Jul 03, 2011 02:36 PM