Yes..

the DT750 will fit..

have a bolt pattern for them.. and include hardware,
Just add a note what motors you plan to use.

the current gear will work on 1/2 and 3/8 booms all include.

Luis.

Thanks Luis I totally forgot to text u lmao. I figured those motors would for since you have used them before.

@little g all of my landing gear have fit my booms no problem. Airbagit and the other guy were using the 1.3 frame though and there's been 3 more frames since then.

Originally Posted by flohio117

Thanks Luis I totally forgot to text u lmao. I figured those motors would for since you have used them before.

@little g all of my landing gear have fit my booms no problem. Airbagit and the other guy were using the 1.3 frame though and there's been 3 more frames since then.

flohio117,

Getting close to pushing the "BUY" button on this FPVDM...

Can you list your onboard FPV equipment and grounstation equipment?

Also, I like to know the type, length, and dimensions of the booms you used on your FPVDM 1.5.

Gopro for recording and camera
EZosd with current sensor
400mw 1.3ghz vid tx with cloverleaf antenna

Ground station.
1.3ghz rx with skew planar wheel
Fatshark goggles.

14 inch 3/8 booms

Well flohio117, I think it's time to replace the frame. I crashed my tricopter while flying FPV. I didn't know what really happened. I was flying about ~5mph and ~25ft above the ground. All of the sudden, the tricopter rolled left and dropped out of the sky. The tail assembly and the left motor mount cracked.

My girls were mourning over my lost except for wife as seen in the photo. Actually, she felt bad for me.

@little G man that sucks but its more of a reson to get a waaay! better and stronger frame now by the way your wife is just like mine when i crash lmao. well sometimes mine feels bad. just think now if you get the fpvdm you will avtually have a frame designed for fpv and that has tons of roooooom!

Originally Posted by flohio117

@little G man that sucks but its more of a reson to get a waaay! better and stronger frame now by the way your wife is just like mine when i crash lmao. well sometimes mine feels bad. just think now if you get the fpvdm you will avtually have a frame designed for fpv and that has tons of roooooom!

About to the place the order, but need your help in placing it...

I like you're setup and would like to exactly mimic it. Is there anything I need to specify in the order before placing it?

Originally Posted by LittleG

About to the place the order, but need your help in placing it...

I like you're setup and would like to exactly mimic it. Is there anything I need to specify in the order before placing it?

you want to mimic like the same motors also?

Actually, using my existing DT750 motors as they are more economical than the ones you have on your tricopter... I think yours cost at least 30bucks a pop, right?

Also, sent you a pm.

Yeah around there.

I hasn't gotten your pm but just tell Luis that you want motor mounts that have cages that will work with your dt750s and the rest of the tri is normal.

I ordered the FPVDM today... Can't wait to see it.

Awesome I know you'll love it! Don't forget to thank me later lol.

I'll be using the KK2 board with this. What size servo do you recommend?

How much does all the frame gear weigh? And are there any close up shots of the yaw mech?