|Mar 12, 2014, 05:23 PM|
Looking for a replacement airframe -->
I've been out of the micro loop for awhile.
I've searched but can't seem to find what I'm looking for, and hoping someone here is kind enough to point me in a direction.
I was flying the Horizon UMX micro Extra.
It's beat up pretty bad now.
I would like to find something that flies comparable and would like to know what
my options are.
Hoping to transfer the brick and gear to another airframe.
It doesn't have to be the tiny foam and light film type, just something that flies
like the UMX and will accept the gear that is in it.
It uses the 150~180 single cell batteries.
Thanks for any help
|Mar 13, 2014, 01:58 AM|
Micro Motor ?
Now that I have a couple of micro's on the way, what's the hot replacement motor
I have one of these --> http://www.horizonhobby.com/products...x-20mm-EFL9052
and one of these --> http://www.horizonhobby.com/products...x-20mm-EFL9052
I also have this brick --> http://www.horizonhobby.com/products...-esc-SPMAR6410
|Mar 13, 2014, 09:17 AM|
Fond du Lac, WI
Joined Mar 2005
Be sure that when you install the brick (receiver+ESC+servos) that it is in the same orientation in the new plane that it was in the original plane.
The DF200 and the Dynex F3P are both good flyers.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||FFM 350 QX (Replacement airframe for Blade 350 QX) ***Official build***||BrainDrain_dx||Multirotor Talk||24||Mar 14, 2014 06:06 AM|
|Found||Looking for nitro airframe for mossburgh 12ga||benysjets||Aircraft - Fuel - Helis (FS/W)||2||Jan 05, 2014 10:56 PM|
|Discussion||Off topic looking for airframe suggestions||Canada Goose||Aerial Photography||1||Nov 08, 2013 02:28 PM|
|Wanted||Looking for a nice 90mm airframe.||DumthumbsFRANKIE||Aircraft - Electric - Jets (FS/W)||9||Oct 21, 2013 07:12 AM|
|Wanted||looking for a nice used plantraco carbon butterfly replacement airframe.||crash8384||Aircraft - Electric - Micro & Indoor Airplanes (FS/W)||0||Feb 02, 2013 07:33 AM|