|Dec 17, 2012, 05:32 PM|
Joined Nov 2007
How to swap the gear for nine eagles motor
Hi, I have difficulty putting parkzone gear on nine eagles 8.4mm motor. With my needle nose pliers I can push the gear in about haft of it length. Any suggestion on how to push the gear would be much appreciated!
|Dec 17, 2012, 08:01 PM|
Set the gear on end on a piece of scrap lumber. Heat the gear with a soldering iron until it starts burning the wood. Remove the soldering iron and push the motor shaft into the gear applying pressure to the end bell of the motor. It will slip right on and should stay put after it cools.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||Cox / Nine Eagles Micro Motors (for Cox Xtra or Sky Cruiser)||ShokWaveRider||Aircraft - Electric - Power Systems (FS/W)||0||Jul 31, 2012 01:14 PM|
|Discussion||nine eagle 180, how to revert tail gyro correction?||eders||Micro Helis||3||Mar 08, 2012 12:38 AM|
|Discussion||Nine Eagles Solo Pro landing gear - How are you fixing it?||Recoplon||Micro Helis||6||Feb 18, 2010 10:44 AM|