|Dec 10, 2012, 04:33 PM|
Joined Dec 2012
Filling rigid dirigibles?
Quick question: looking around, I've seen a few models of what appear to be rigid dirigibles. How exactly are those filled with lifting gas? Are there individual gas bladders inside the structure that can be deflated, or is the entire 'envelope' used to hold gas, and if so, how do you let the oxygen out in order to let the helium in? Thanks!
|Dec 12, 2012, 03:28 PM|
Joined May 2005
Concerning my own rigids, my R-100 (http://www.rcgroups.com/forums/showt...ighlight=r+100) had a single internal bag which was filled thru a tube at the tail cone. This of course means the rings can have no internal bracing.
I have since built a model LZ5, which was described in website airshipmodeler.com, now apparently defunct. It had no internal bags, using the outer covering as the gas membrane. It was filled by lifting it to a nose down position, and introducing helium into the tail end. The air flowed out thru a larger hole near the nose. After about twice the volume had been put thru, it was light enough to lift. After 3 times the volume, it was virtually pure He inside. Then the nose hole was taped up. The greatest problem with this design is sealing the outer cover at all the seams and penetrations for struts, bracing wires, etc.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||HeliCommand "Rigid" Stabilization system||Swashmix||Aircraft - Electric - Helis (FS/W)||3||May 28, 2012 07:03 PM|
|Discussion||Dow 1/2" super rigid foam Polyisocyanurate Rigid Foam Insulated Sheathing||inline300||Foamies (Scratchbuilt)||7||Aug 15, 2009 05:55 PM|
|"rigid membrane" with inhomogeneous rigidity||Xdim||Ornithopters||10||Mar 11, 2005 12:03 AM|
|Question||Non-Rigid, Semi-Rigid, and Rigid||WillowPtarmigan||Blimps||1||Nov 05, 2004 02:48 PM|
|Super Cub- To Fill or Not to Fill?||rtucker||Beginner Training Area (Aircraft-Electric)||6||Jan 16, 2002 02:47 PM|