|Sep 21, 2012, 12:58 PM|
United States, OH, Troy
Joined Jan 2008
Centering DX6i Gear Channel?
Don't really know where else to put this question : Is there a way to center the gear channel and deactivate the gear switch on a DX6i?
|Sep 22, 2012, 03:55 AM|
I don't have that radio but I would try using the travel adjustment on the gear channel. Set the travel to zero in both directions then it won't matter which position the switch is in.
Then use subtrim on the gear channel to fine tune where you want the neutral position to be.
|Sep 22, 2012, 10:04 PM|
use this little program mix (patent pending)::
MAS (master)=GEAR, SLV (slave)=GEAR, MIX=-100%, -100%, SWT (switch)=ON (always on)
(check pages 70 to 73 in your manual)
how it works?
switch down tells move -100%, but the program tells move the same but in the other way at the same time, then remains at 0 position (center).... the same with switch up...
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||DX8 Airware 2.05 channel centers and end points not the same as 2.04?||Elios000||Radios||2||Oct 22, 2012 07:38 AM|
|Sold||Spektrum DX6I DSMX six channel with four 6 channel receivers||NZ7C||Aircraft - General - Radio Equipment (FS/W)||1||Sep 18, 2012 06:57 PM|
|Help!||How to center JR DS285 servo last gear||gmg2001br||Electric Heli Talk||3||Jun 17, 2012 09:18 PM|
|Question||DX6i programming flap and gear channel||chachaya||Radios||5||Dec 09, 2010 08:47 PM|
|Help!||Can I turn my Navigation lights on and off with my DX6i and gear channel on RX||dolbydarma||Night Flying||6||Nov 17, 2010 06:49 PM|