|Aug 26, 2007, 10:04 AM|
Oswestry, Shropshire. UK
Joined Jul 2007
8ch JR combo failed range test today
Been flying 8ch setup with a JR9X2 (9303) and did have a couple of small glitches (even though range test was ok)when i first test flew my Knight 50 3D, thought i'd put it down to a low battery voltage.
Well today had some nasty glitches close in and quickly landed. Well it failed a range test. Battery had just been charged and the only thing i had changed recently was to flip the metal tx handle around. Couldn't work out the cause as to why the range test was so poor then in desperation pulled the module and reinserted it. This cleared the problem and the subsequent range test was great.
Guess i had a dirty connection between tx and module? Wonder if this solution might be of use to someone. Is there any sort of application i can smear on the pins to ensure a good connection? Conductive paste of some sort?
|Aug 26, 2007, 10:43 PM|
I swear by DeoxIT ProGold 100 for enhancing electrical contact. I put this on all servo connections as well as the module/tx connector.
You might also want to open up the Tx and ensure that it isn't a solder joint that connects the PCB to the module connector that is now becoming bad..
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Air/JR/Fut RX Range test/results article in 3-D Flyer Mag.||Peter Khor||Radios||3||Aug 26, 2005 11:07 AM|
|JR 610M receiver range||HIGHFLYER99||Electric Plane Talk||38||Jan 19, 2004 02:36 PM|
|Acceptable range test distance?||Jeff Kelety||Parkflyers||5||Dec 22, 2002 03:03 AM|
|New Futaba 9C won't range test properly||astroboy||Radios||7||Oct 22, 2002 05:07 PM|
|Miracle Rcvr or Hardway Range Test||KillerWatt||Parkflyers||0||Nov 27, 2001 01:28 AM|