|Jan 02, 2013, 04:32 PM|
V939\V202 LED Mod
The LED holders on the WL toys V939 and V202 quads mask alot of the LED light. In addition, on a hard crash you can lose them. Not to worry. Simply take some heat shrink and pre-shrink it on a screwdriver shaft and slide it over the LEDs
I used 3\16th shrink tubing and just picked a Philips head screwdriver that was slightly smaller than the diameter of the LED holder. Cut the heat shrink to about half the length of the stock holder. You can always trim after you shrink it as well.
Heat shrink cut and ready to be shrunk:
Installed, compared to stock holder (left is stock, right is heat shrink):
Light test, left is new, right is stock:
Now the V939\V202 can give the Mini Pet a run for its money at night Thanks to Bill for the idea to use heat shrink.
There's also a straw mod you an do by simply cutting some short lengths of straw and placing them over the existing LED holders for that fiber optic effect:
|Jan 03, 2013, 04:52 PM|
Joined Jun 2012
going to mount as soon as will arrive new pcb spares!
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||LadyBird Qr SMD Led's mod, even more led's to come!||croyal918||Multirotor Talk||6||Jan 13, 2014 07:15 PM|
|Mini-HowTo||V911 Night Glow (Canopy LED Mod) and Maiden Flight||mrmarc||Micro Helis||25||Mar 11, 2013 05:20 PM|
|Build Log||Slow Stick for AP with Mods, Aiptek cam mod, Strip LEDS for night flight(Plane RTF)||TaSaJaRa||Aerial Photography||44||Sep 08, 2009 09:01 AM|
|Discussion||Even easier LED mod..... no show and 2 LEDs!||Ironbowser||Micro Ready-to-Fly||4||Sep 02, 2008 06:42 PM|
|Discussion||New LED source at Walmart & Doing the LED mod||KC||Micro Ready-to-Fly||7||Mar 18, 2007 06:45 PM|