|Nov 10, 2012, 01:59 AM|
Optic 6- problem with buzzer
Today I done some tests of servos, ESC, etc. And suddenly buzzer was beeping quietly. When I pushed buttons, I did't hear typical short, loud beeps (buzzer beeped quietly still). I turned it off and on and everything was OK. Is this normal?
|Nov 10, 2012, 01:49 PM|
Joined Aug 2002
It is quite normal for any buzzer to go quiet after 'I done some tests of servos ' when unit has been used extensively
and warmed up with voltage falling under increased resistance. This is no different to laptops, cell phones and other
electronic gadgets where turning on & off again clears system and batteries will also recover somewhat.
(perhaps even a little electrostatic modelling dust held or blocking holes will be able to fall out during the off period).
If after batteries have been fully recharged, external influences are good, situation reoccurs and you are still concerned,
as per previous advises, contact the Hitec distributor in your country for service.
Alan's Hobby, Model & RC FAQ Web Links
|Nov 11, 2012, 07:22 AM|
I'm not sure I tested servos at that moment. Suppose, I did not but it's strange behavior happened only once. Could this mean that the TX is broken?
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||Decision, hitec Optic 6, Optic 6 sport, dx6i OR??||MikeontheBike||Radios||38||Sep 21, 2012 10:42 PM|
|Discussion||Optic 6- trimmers- problem||Bart10||Hitec/Multiplex USA||5||Sep 02, 2012 01:16 AM|
|Help!||Optic 6 gimbal problem?||nchcs||Hitec/Multiplex USA||2||Jul 08, 2012 06:46 PM|
|Help!||Problem with my radio (Hitec Optic 6), lost signal often||jordanmeir||Radios||3||Jun 27, 2012 04:49 AM|
|Help!||Optic 6 problem||Bart10||Hitec/Multiplex USA||9||Jun 18, 2012 03:23 PM|