HobbyKing.com New Products Flash Sale
Reply
Thread Tools
Old Nov 14, 2011, 10:28 AM
Registered User
USA, CA, Los Angeles
Joined Jun 2010
491 Posts
Question
Collar on Prop Shaft

What is the point of the collar that goes on the prop shaft if you decide to use the opposite side of the motor. There's a little pin, do I take that before putting the collar on or just slide it over. I'm taking about A series motors
chriscap is offline Find More Posts by chriscap
Last edited by chriscap; Nov 14, 2011 at 10:56 AM.
Reply With Quote
Sign up now
to remove ads between posts
Old Nov 17, 2011, 01:56 PM
Registered User
USA, CA, Los Angeles
Joined Jun 2010
491 Posts
Anyone?
chriscap is offline Find More Posts by chriscap
Reply With Quote
Old Nov 17, 2011, 06:41 PM
Registered User
Wallingford, Ct
Joined Sep 2001
1,909 Posts
I have been hoping someone would answer it also.
Al M is offline Find More Posts by Al M
Reply With Quote
Old Nov 17, 2011, 06:46 PM
Registered User
USA, CA, Los Angeles
Joined Jun 2010
491 Posts
Since I didn't get an answer here, I asked elsewhere. Here are the results

http://www.rcgroups.com/forums/showt...10083&page=585

Around post 8771
chriscap is offline Find More Posts by chriscap
Reply With Quote
Old Nov 18, 2011, 06:12 AM
Registered User
Wallingford, Ct
Joined Sep 2001
1,909 Posts
Thank you.
Al M is offline Find More Posts by Al M
Reply With Quote
Reply


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Sold Solo Pro/Bravo SX Aluminium Parts (swash, collar, main shaft and rotor head) bobepine Aircraft - Electric - Helis (FS/W) 1 Sep 07, 2011 08:10 PM
Discussion Msr shaft Collar darimont Micro Helis 3 Sep 07, 2011 01:52 PM
Wanted WANTED! MCX Inner Shaft with hub, Outer shaft collar, main gear collar screws rcpilotjr Aircraft - Electric - Helis (FS/W) 1 Apr 26, 2010 08:44 PM
Discussion Any hints on removing collar on outer shaft v3 BIRDDOG987 Coaxial Helicopters 4 Mar 25, 2008 01:48 PM
Question Shaft collar and the 'old'? plastic spacers on shaft?? markswift Micro Helis 8 Jun 11, 2004 04:49 PM