Norway, Akershus, Aulifeltet
Joined Mar 2013
DJI NAZA problems after installing new landing gear
I recently upgraded my quadcopter with a new landing gear. My quadcopter is now heavier than before.
I tried it today, but I experienced two different problems.
A. When yawing in GPS mode it drifts easily away from its position, and regains stability some seconds after yaw stop. It also seems like it doesn't hold it's GPS position as good as before. It drifts back and fourth.
B. I switched to failsafe (only auto land), it landed exactly where it should, but way too fast. The descending rate was to fast so it hit the ground too hard, and it flipped over.
All the gains are at 120%. I didn't change them after I installed the new landing gear. The voltage was at 3,4 pr cell when I flipped the switch to failsafe (voltage buzzer). I have the latest firmware 3.12.
So my questions are:
1. Will changing the vertical gain change anything with the auto landing in failsafe? (Increase for softer landings, maybe?)
2. Which parameters should i change, and in what direction for increasing stability when yawing, and holding GPS position?
3. Does anyone have a similar setup, and can share their settings? (This is a Storm FF drone - Like a upside down F-450 with 1100kv motors)
This is how it looks now:
This is how it looked before I changed landing gear:
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Poll||Skywing scale Edge/Slick and Future Model Sbach: would you install wire landing gear?||groovejet||3D Foamies||34||Dec 07, 2014 08:48 PM|
|Discussion||Strange behaviour after installing new motors (Turnigy NTM Prop Drive 28-36 750KV)||rvbcrs||Multirotor Electronics||5||Apr 28, 2013 05:40 AM|
|Question||Landing gear problem||cmdl||Electric Plane Talk||22||Apr 16, 2013 02:55 PM|
|Question||How to install landing gear in this Bipe?||engineMagnet||Vintage & Old-Timer Designs||9||Mar 30, 2013 09:51 AM|
|Slow Stick Cof G problems after new Brushless Motor installation||simonbryant||Parkflyers||20||Jun 18, 2004 10:50 AM|