|Dec 05, 2013, 06:27 PM|
|Dec 06, 2013, 03:40 AM|
|Dec 06, 2013, 04:30 AM|
http://ecilop.com/data/cam_controller.phtml or have you found a way to do it via IR without dissecting the camera?
|Dec 06, 2013, 07:40 AM|
|Dec 08, 2013, 09:16 PM|
An updated description of the Force Servo.
It is capable of rotating cameras of any mass - from GoPro to ARRI and IMAX
Video, Part # 1. What is Force Servo? :
Video, Part # 2. Photo/video camera stabilization:
Video, Part # 3. Vehicle control:
|Yesterday, 11:45 AM|
I got a question about the reasons behind servo drive vibration (Ecilop Easy, Force Servo).
I have a few assumptions on this matter:
1. Weak line tension (the small spring must be stretched from 10 to 20mm).
2. High gain value for the gyroscope (when lowered, vibration
3. The gyroscope housing gets vibrations from the servo drive (use soft
gaskets with a metal plate for the gyroscope and bend the wire into a loop)
4. A defect in the potentiometer (vibrations usually occur when the
potentiometer rocker is in a particular position).
5. Gear jamming (the servo drive arm can be hardly rotated with fingers
when the power is off).
6. The position controller generates a strange control signal (can be
checked with a servo tester).
According to the manufacturer, the operating life of the potentiometer is
no fewer than 1,000,000 rotations.
If the gear assembly is jamming, the following may help:
Disassemble the servo drive, turn the clogs on all axes manually, make sure
that nothing is jamming any more, assemble the drive.
We have tested each and every modified servo drive.
This is a demo of a fully functional servo drive:
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Five easy piece f-14 tomcat||bobdaeronort||Foamies (Scratchbuilt)||80||Oct 25, 2012 06:43 PM|
|Discussion Easy Glider VS Easy Glider Pro (what's different?)||MkFn||Electric Sailplanes||7||Nov 17, 2011 08:42 PM|
|Discussion Easi Glider film||boca55||Serbia||0||Apr 20, 2008 05:46 PM|
|Discussion Spring Easi* in NZ||harrys one||Aerial Photography||8||Nov 14, 2007 02:22 PM|