|Sep 13, 2011, 05:05 PM|
RD6000 PPM Connection Points
I'm trying to install the FrSky 2.4Ghz module into my older Sanwa/Airtronics RD6000 and can't locate the connection points for the PPM signal. Has anyone done this already, and if so, can you point me in the right direction?
|Sep 14, 2011, 06:22 PM|
Success!! My RD6000 is now up and fully functional on 2.4Ghz! It really wasn't rocket science once I was able to locate the PPM access point.
I pulled Gnd off of the gnd1 point on the board, V++ from the top of the on/off switch, and the PPM signal off of the trainer plug.
A quick note here: The trainer plug on the RD6000 is a bit strange. Looking at the plug from the front, the signal in lead is at the far right, or Pin 5 if counting clockwise from the left. What's strange, is that the lead on my xmtr was black! Who uses black as a signal lead? There's a diagram of the plug at: OnGuard has posted an image of the plug at: http://www.rcgroups.com/forums/showt...1098611&page=7
This little adventure wouldn't have been possible without the help of Scott Morton. Scotty, a big shout out and THANK YOU! for your time and advice.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion PPM connection for Sanwa RD6000 2.4GHz conversion||plane_spotter||DIY Electronics||1||Sep 13, 2011 05:00 PM|
|Sold Airtronics RD6000 6-Channel PPM||3D4ever||Aircraft - General - Radio Equipment (FS/W)||2||Apr 21, 2007 04:46 PM|
|For Sale RD6000 Super 6 channel PPM FM transmitter||GirlsFlyToo||Aircraft - General - Radio Equipment (FS/W)||0||Nov 28, 2006 12:11 PM|
|Discussion tail motor wiring connection points on rx?||tigheger||Micro RTF||2||Sep 02, 2006 04:09 PM|
|Discussion Butterfly Receiver Connection Points||ifxmnfly||Indoor and Micro Models||8||Feb 28, 2006 07:54 PM|