|Feb 05, 2013, 06:30 PM|
Joined Feb 2013
eagle tree guardian
I installed and tested by moving on all axis,the control surfaces only move a small amount.Gains are all the way up. Control surf. move normally when using sticks.I am using dx5,but recently purchased dx7. could it have something to do with transmitter? receiver is 6 channel.
|Feb 22, 2013, 11:37 AM|
I haven't used the eagle tree but did use another 3 axis gyro the orange x. And control surface movements were small. I think that it reacts quickly enough that small inputs are all that is needed. If you have too large movements, the danger of airframe shaking oscillations result.
I think the recommendations are that you start with just perceptable movement when you twist it about by hand.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion eagle tree guardian||bushpilot05||Radios||2||Feb 24, 2013 02:04 PM|
|Discussion easystar + osd eagle tree + guardian||xipho3||Video Piloting (FPV/RPV)||1||Jan 04, 2013 10:40 AM|
|Sold Eagle Tree Guardian Stabilizer||Crist Rigotti||FPV/RPV - Equipment and Vehicles (FS/W)||2||Mar 20, 2012 02:19 PM|
|Wanted Eagle Tree Systems Guardian||shlomi4046||FPV/RPV - Equipment and Vehicles (FS/W)||1||Nov 12, 2011 11:11 PM|
|Wanted Eagle Tree Guardian module||ajhaggerty||FPV/RPV - Equipment and Vehicles (FS/W)||0||Oct 06, 2011 12:08 AM|