Joined Feb 2013
binding works but servo/motor do nothing
Hi. My dad and i are trying to get our bixler 2 set up and are having huge issues partly due to us being pretty new to this and also because there are next to no instructions on how to wire the damn thing and/or use the turnigy 9x controller.
The main problem is when we bind the transmitter/ receiver the red light turns solid but still get no power to any servos or the motor.
Also when I disconnect the battery and turn off the controller it seems to lose the binding. When I turn it back on the red light is back to flashing.
This is a gift from my dad and its getting to the point where we are doubting whether we will see it fly before the weekend is over.
As I'm doing this all from my phone researching is pretty difficult so I decided to post here.
Thanks for any help and advice anyone can give.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||Orange Rx binds but throttle ch. will not work.||Pilot in MO||Radios||4||Jul 07, 2013 11:02 PM|
|Wanted||4 Servos.....Low cost but good working order||Rob5954||Cars - Accessories (FS/W)||4||Feb 02, 2013 03:45 AM|
|Discussion||Frsky and er9X - D8R-II Plus binds, but servos don't work||Zangetsu57||Radios||10||Sep 08, 2012 01:09 AM|
|Discussion||Spektrum 6200 Rx binds, but nothing else !?!?||SkyEyes||Radios||13||Sep 21, 2011 03:23 AM|