|Nov 18, 2012, 11:43 PM|
Canada, BC, Squamish
Joined Jul 2009
Can't acess program mode for ESC
I have just replaced the ESC in my Blade 300X heli with a E-flite 30 amp Pro that I have used previously in another heli.
As I recall I have been able to program this ESC in the past but now cannot get into program mode. The ESC works fine, and I only want to go through the program steps to confirm settings, etc. specifically soft start. I have followed the directions to the letter, tried increasing throttle end points, played with throttle trim, etc. to confirm that the ESC is seeing full throttle, which is what it needs to access program mode. I have been using LiPos at storage, rather than full, charge, and wonder if that would make any diffrence. Any other ideas?
Thanks for any replies.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Help!||rctimer SK-20A esc can't enter calibration mode||emuer||Multirotor Electronics||5||Nov 18, 2012 02:26 AM|
|Help!||Can't program Suppro 18A ESC , stuck !||fltekdiver||Power Systems||1||Feb 24, 2012 08:03 PM|
|Discussion||Eflite ESC, can't get into programming mode?||rperego||Power Systems||1||Feb 17, 2008 01:47 PM|
|Discussion||Eflite ESC, can't get into programming mode?||rperego||Beginner Training Area (Aircraft-Electric)||1||Feb 17, 2008 01:46 PM|
|Can't enter programming mode on a new Phoenix-25 ESC||Foam Crazy||Castle Creations||9||Aug 13, 2005 12:57 AM|