|Mar 07, 2013, 09:14 AM|
Joined Jan 2009
Glider - how to hook up eloggerV3
I would like to install my eloggerV3 in my F3F glider, (no motor)
The goal is to get information about total current beeing drawn by the whole rc equipment.
do I hook up the rx battery into the BAT port of the elogger, and then the receiver to the ESC port? (would use two servo connectors that go into the rx)
thanks for answering.
|Mar 07, 2013, 06:54 PM|
That should work. The issues you may encounter are issues when the voltage drops below around 4.5 volts, and issues dealing with the resolution of current logging with the eLogger.
Another option would be our servo current monitor, which has much higher resolution current sensing, but it's an eLogger accessory, so you'd still need the eLogger to be powered.
We've had a standalone receiver/servo current monitor on our list for ages, but never seem to have time to get to it.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Question||How to hook up to FMS||Bob A||Electric Plane Talk||9||Mar 04, 2013 06:48 PM|
|Discussion||X-POST from talk: How should I build a connector for my Lipo to hook it up to my PCB?||hamsterchaos||Scratchbuilt Multirotors||0||Feb 28, 2013 04:10 AM|
|Discussion||FPV on a budget? Hook me up if you can!||Endlesslag||FPV Talk||6||Jan 13, 2013 10:25 PM|