|Jun 01, 2014, 12:16 PM|
AS3X and Corrosion-X??
I've been out of the water for about a year. Spent a lot of time flying helicopters last year. I went out to the lake last week and had a blast. I got a new CZC and I ordered a Sport Cub too both with floats.
Has a verdict been reached yet on the use of Corrosion-X with the AS3X equipped receivers? Will the sensors work ok after they've been treated?
|Jun 23, 2014, 09:33 AM|
Well, since I got no replies I figured I'd put a post here for others. I treated the AR635 in my Carbon-Z Cub and there were no ill effects at all. Remember with AS3X the receiver needs to be positively connected to the airframe, so I suggest removing the case, treating the board only, and then carefully re-installing the case without getting any corrosion-x on the case. That way you can use 3M double sided tape to attach the rx to the airframe.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Sold||AR635 6-Channel AS3X Sport Receiver and 4 x E-flite EFLR7145 Digital MG Mini Servo||ap_rpm||Aircraft - General - Radio Equipment (FS/W)||5||May 25, 2014 09:30 PM|
|Sold||parkzone um t-28 with as3x gyro and 2500kv bl motor, 2 x 2s 200mah||IceRain29||Aircraft - Electric - Micro & Indoor Airplanes (FS/W)||2||Nov 10, 2013 02:19 AM|
|Sold||parkzone um t-28 with as3x gyro and 2500kv bl motor, 2 x 2s 200mah||IceRain29||Aircraft - Electric - Airplanes (FS/W)||2||Nov 10, 2013 02:12 AM|
|Discussion||nCP X, mCP X [BL] or 130X w/ AS3X and SAFE?||fryfrog||Micro Helis||0||Jul 26, 2013 11:35 PM|