|Jan 01, 2013, 03:11 PM|
Joined Jul 2009
I have some troubles arming my hoverfly pro.
When I arm it inside my house where it is 20 degrees it is ok, but when it is outside in + - zero degrees it will not arm.
It just beeps and doesnt activate so I can arm it with the rudder stick.
And if I arm it inside and take it out flying in the cold it stays armed and works fine.
Has this to do with the temperature calibration in the setup client??
What can i do to fix this??
|Jan 02, 2013, 07:28 AM|
Joined Jan 2011
I dont know if the temp calibration will fix that. It could be a number of things being affected by the cold all the way from the radio to the esc's to the board. Next time try lowering the throttle trim till the beeping stops if the board wont arm.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion||What is the critical temperature (or ambient temperature) for foam?||Litchking||Electric Plane Talk||5||Apr 17, 2012 10:05 PM|
|Discussion||Temperature Calibration Failure||RC Man||Hoverfly Technologies||17||Oct 10, 2011 10:38 AM|
|Discussion||Temperature calibration||elossam||Hoverfly Technologies||10||Oct 03, 2011 03:51 PM|
|Discussion||Temperature calibration of finger||cjoregon||Electric Motor Design and Construction||1||Jun 15, 2007 07:24 PM|
|Temperature gauge calibration||mudzilla||Off-road Cars||5||Sep 02, 2005 03:22 AM|