|Aug 14, 2013, 05:10 PM|
Motor System Issue
I have a Spectra, a Rimfire .10 to a 35 amp Silver Series ESC off a 2200 mAh,3S battery. I connected to do a power check and the ESC had a constant beep. Disconnected the battery, double checked connections, radio. Plugged back in and still the constant beep. Changed out the ESC for another Silver Series 35 amp ESC and I am still getting the constant beep and I am at a loss as to why. I am still quite new to electric so I need HELP !!!!!
What am I missing?
|Aug 14, 2013, 07:13 PM|
Problem solved. I had the travel volume set at 10% turns out it needed to be 100%. After i got that set right everything works fine
|Aug 14, 2013, 07:17 PM|
USA, AZ, Mesa
Joined Oct 2004
The problem may be that the throttle is in the high position. Are you using a servo tester or a TX/RX as your control input?
If you are using a Futaba radio, the 'polarity' of the throttle is reversed from 'standard'.
Try reversing the throttle. otherwise there may be an issue with the battrey voltage. If the ESC s set up for 4 cells, and you connect only 3 cells, the motor will not run, and the ESC may signal by beeping.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Discussion Please Help!! Motor surge/burst issues with Avroto 2814 Motors on DJI F550||svitosky||Multirotor Talk||2||May 30, 2013 09:27 PM|
|Discussion Eflite Carbon Yak: help w/power system issue||sothpaw||3D Foamies||1||Mar 02, 2013 08:07 AM|
|Discussion T-Motor 800kv, question / possible issue?||Tharr62||Multirotor Talk||3||Feb 03, 2013 09:45 PM|
|Help! CB100 issues/fault - Motor or ESC (or something else?)||een7gdr||Micro Helis||2||Jan 24, 2013 02:54 PM|
|Discussion 3506 T Motors - Bearing Issues||wrong17||Multirotor Talk||0||Jan 23, 2013 02:18 PM|